Operating instructions for UNIVERSAL_威尼斯赌场_澳门现金网-【app*官网】

takami
Fri, 24 Apr 2015 07:33:45 +0000
Machine

Printing from CorelDRAW

Right click on file → “Open with program” → Choose “CorelDRAW”Right click on file → “Open with program” → Choose “CorelDRAW”

For the pop-up, choose “curved line”

Except for the layer that you will print, you need to click the “Print/do not print” printer icon and set everything up

From Properties → Confirm color and width of line with the “Pen icon” at the bottom right of the screen

Go to “File” on the Menu Bar, and click “Print”

Confirm if the designated X is “VLS2.30”

Click “Properties”

Settings for materials with specialized software

Select the “Material Database” tab on the left side of the screen

Select material from “Category”

Select thickness and materials → if not available it will be necessary to create the setting, so please consult the staff

Once finished with selection, select “Manual Control”

Confirm that the “Z-Axis” column is “OFF” → If it is ON, the table will operate on the set thickness, but at present, this function is not used.

When “ON”, put the processing settings into selection mode, and set the A area on the screen to “OFF” → Click the “Set” → “Apply” → “OK”

After pressing the “Print” button, click the “ULS” button at the lower right side of the monitor to move to the ULS screen

Press the “Power” button at the top right of the screen and turn the processing machine

Setting focus point for processing machine

！WARNING！Do not consecutively press the lift button for the processing machine! The machine will start to move quickly and be unable to stop, and doing so will be cause for malfunctions

Place materials on the metal fittings of the table

Confirm that the materials and the lighting head aren’t touching, and move the head over the materials using the “Focus View” mode

Position the jig, and adjust the height using the table’s lift button

You can also raise the table by using the button on the ULS screen

Make sure to completely close the lid of the operation area → If not shut properly, it will touch parts of the processing machine

However, if you put too much stress on the processing rails, they will bend, so please be careful of that

Confirming processing position & material position

Select “Focus View” from the pull-down menu on the USL screen

Set the cursor to the position of the processing data, click, and the head will move

When moving the processing data, select “Relocate View”

You may either drag & drop the data to your desired location, or you may input coordinates

Turn on Air Assist & Dust Collector

Turn on the power to the Air Assist on the desk for the PC monitor

Turn the on the power to the Dust Collector

Start Processing

Press the “Start” button for the ULS, and begin processing

If, during processing, the materials start burning, etc., open the lid to the processing machine, do a “force-quit” and put out the flame

When you must stop for whatever reason, use the temporary stop button → There are instances when the machine does not recover

Remove items and clean

Cleaning method (a write-up will be written at a later date)